VRF and VRV systems in Derbyshire
VRF and VRV air conditioning in Derbyshire, sized to the real heat load of your premises rather than guessed from the floor area.
- Free site survey and fixed written quote
- Unit sizes, refrigerant and price set out in writing
- Work planned around your opening hours
How much does a VRF system cost in Derbyshire?
Budget roughly £2,395–£4,850 per indoor unit (whole system) ex VAT in Derbyshire. For a typical job — office floor of 10–16 indoor units — expect £23,995–£77,995 plus VAT. Your exact price is fixed in writing once we have surveyed.
VRF (variable refrigerant flow) — called VRV by some manufacturers — is a commercial air conditioning system where one outdoor unit, or a bank of them, serves many indoor units through a shared refrigerant network.
Where we work around Derbyshire
We cover all of Derbyshire, including Derby, Chesterfield, Long Eaton, Ilkeston and Swadlincote. Wherever your premises are, the survey, quote and installation follow the same steps.
Postcode districts we cover include DE1, DE11, DE23, DE72, NG16, S33, S45 and SK23. In Derbyshire, outdoor unit positions are often the deciding factor: a rear flat roof or yard is usually straightforward, while a front elevation may need landlord or planning consent first.
What is included
- Two-pipe (heat pump) or three-pipe / two-pipe heat recovery system design
- Refrigerant pipework sizing, branch selectors and refrigerant charge calculation
- Leak detection where the refrigerant concentration limits require it
- Central controls, scheduling and BMS integration
- Phased installation, pressure testing, commissioning and full F-gas records
Guide prices in Derbyshire
Prices below include our regional adjustment for the East Midlands (2% below the UK guide).
| Item | Guide price (ex VAT) | Inc VAT | Basis |
|---|---|---|---|
| Heat pump VRF, per indoor unit | £2,395–£4,350 | £2,874–£5,220 | per unit |
| Heat recovery VRF, per indoor unit | £2,895–£4,850 | £3,474–£5,820 | per unit |
| Central controller and BMS interface | £925–£3,850 | £1,110–£4,620 | per system |
| Refrigerant leak detection (per alarmed room) | £385–£875 | £462–£1,050 | per room |
| Crane lift for roof plant | £925–£2,895 | £1,110–£3,474 | per lift |
Ex VAT, installed system prices including outdoor plant shared across indoor units.
From enquiry to handover in Derbyshire
Survey and loads
We calculate loads zone by zone and check roof or plant space, risers and ceiling voids.
System design
Outdoor units, indoor units, branch boxes and pipe sizes are designed together, including the refrigerant charge and any leak detection.
Phased first fix
Pipework and controls cabling go in floor by floor, often out of hours in occupied buildings. We keep work areas in Derbyshire screened and tidy at the end of each day.
Pressure test and charge
The network is pressure tested, evacuated and charged with the calculated refrigerant quantity.
Commissioning
Each indoor unit is commissioned and the controls set up, with as-fitted drawings and F-gas records handed over.
Before you book in Derbyshire
Refrigerant in occupied rooms
Because one network carries a large refrigerant charge, small rooms on the system are checked against the safety limits in BS EN 378 and may need leak detection.
Conservation areas
Historic streets and listed buildings in and around Derbyshire are more likely to need planning permission for outdoor units on visible elevations. We check with the local planning authority before work is booked.
Plant space
Outdoor units need clear air flow, structural support and safe access for servicing.
Leased premises
If your Derbyshire premises are leased, the landlord's written consent is usually needed for external units, wall penetrations and roof access. We provide drawings and data sheets for the request.
Premises we work in around Derbyshire
- Offices: zoned cooling and heating for open-plan floors, meeting rooms and comms rooms.
- Hotels and hospitality: quiet bedroom units, public-area cooling and heat recovery for hotels.
Compliance in England: refrigerant work falls under GB F-gas rules, and buildings with more than 12 kW of air conditioning in total need a periodic energy inspection (often called TM44).
Questions about VRF / VRV in Derbyshire
How much does a VRF system cost in Derbyshire?
Guide prices in Derbyshire run from about £2,395 to £4,850 per indoor unit (whole system), plus VAT. A typical job (office floor of 10–16 indoor units) costs £23,995–£77,995 plus VAT. We fix the price in writing after a free survey.
Do you also cover Nottinghamshire, Staffordshire and South Yorkshire?
Yes. Alongside Derbyshire, we also cover Nottinghamshire, Staffordshire and South Yorkshire. Each has its own page with local guide prices.
When is VRF better than separate split systems?
Usually once you need more than about six to eight indoor units, want central control, or are short of space for outdoor units. One outdoor unit can replace many.
Does a VRF system need F-gas leak checks?
Usually yes. Most VRF systems hold enough refrigerant to exceed 5 tonnes CO2 equivalent, which triggers at least annual leak checks and record keeping.
Get a guide price for Derbyshire
Free survey and fixed written quote. We reply with a guide price or to book the survey.