VRF and VRV systems in Queensferry
A free survey, a clear specification and a fixed price for VRF and VRV air conditioning in Queensferry.
- Free site survey and fixed written quote
- Unit sizes, refrigerant and price set out in writing
- Work planned around your opening hours
How much does a VRF system cost in Queensferry?
In Queensferry, guide prices run from about £2,350 to £4,750 per indoor unit (whole system), plus VAT. A typical job (office floor of 10–16 indoor units) usually comes to £23,500–£76,500 plus VAT. The fixed price follows a free survey.
VRF (variable refrigerant flow) — called VRV by some manufacturers — is a commercial air conditioning system where one outdoor unit, or a bank of them, serves many indoor units through a shared refrigerant network.
Queensferry and surrounding areas
Queensferry is a smaller town in Edinburgh, with independent shops, offices, surgeries, pubs and local business units. Edinburgh is about 14 km away.
That includes premises in EH29, EH30 and KY11 and the surrounding districts. We also work in nearby Broxburn, Dunfermline and Currie. For VRF and VRV air conditioning in Queensferry, the survey looks at where the outdoor unit can go, how pipework will reach the indoor units and whether the electrical supply has capacity.
Included as standard
- Heat load and diversity calculations for every zone
- Two-pipe (heat pump) or three-pipe / two-pipe heat recovery system design
- Refrigerant pipework sizing, branch selectors and refrigerant charge calculation
- Leak detection where the refrigerant concentration limits require it
- Phased installation, pressure testing, commissioning and full F-gas records
Prices in Queensferry
Guide prices for Queensferry, set for Scotland. Your fixed price comes in writing.
| Item | Guide price (ex VAT) | Inc VAT | Basis |
|---|---|---|---|
| Heat pump VRF, per indoor unit | £2,350–£4,250 | £2,820–£5,100 | per unit |
| Heat recovery VRF, per indoor unit | £2,850–£4,750 | £3,420–£5,700 | per unit |
| Central controller and BMS interface | £905–£3,795 | £1,086–£4,554 | per system |
| Refrigerant leak detection (per alarmed room) | £380–£860 | £456–£1,032 | per room |
| Crane lift for roof plant | £905–£2,850 | £1,086–£3,420 | per lift |
Ex VAT, installed system prices including outdoor plant shared across indoor units.
From enquiry to handover in Queensferry
Survey and loads
We calculate loads zone by zone and check roof or plant space, risers and ceiling voids. For sites in Queensferry we confirm access and parking beforehand.
System design
Outdoor units, indoor units, branch boxes and pipe sizes are designed together, including the refrigerant charge and any leak detection.
Phased first fix
Pipework and controls cabling go in floor by floor, often out of hours in occupied buildings.
Pressure test and charge
The network is pressure tested, evacuated and charged with the calculated refrigerant quantity.
Commissioning
Each indoor unit is commissioned and the controls set up, with as-fitted drawings and F-gas records handed over.
Things to check in Queensferry
Plant space
Outdoor units need clear air flow, structural support and safe access for servicing.
Roof and height work
Flat roofs, high walls and atriums need the right access equipment and edge protection. We plan towers, MEWPs or scaffold before the job, not on the day.
Phasing
In occupied buildings we plan the work floor by floor so the business keeps running.
Neighbours and noise
Outdoor units near flats — common above shops — need careful siting so noise at neighbours' windows stays low. We choose positions and quieter units with that in mind.
Who we work with in Queensferry
- Offices: zoned cooling and heating for open-plan floors, meeting rooms and comms rooms.
- Hotels and hospitality: quiet bedroom units, public-area cooling and heat recovery for hotels.
In Scotland, systems holding 5 tonnes CO2 equivalent of refrigerant or more fall under GB F-gas rules, with regular leak checks and records; systems with an effective output of 12 kW or more also need a periodic energy inspection.
Your questions answered
How much does a VRF system cost in Queensferry?
Guide prices in Queensferry run from about £2,350 to £4,750 per indoor unit (whole system), plus VAT. A typical job (office floor of 10–16 indoor units) costs £23,500–£76,500 plus VAT. We fix the price in writing after a free survey.
Do you also cover Broxburn, Dunfermline and Currie?
Yes. Alongside Queensferry, we also cover Broxburn, Dunfermline and Currie. Each has its own page with local guide prices.
Which postcodes do you cover in Queensferry?
All of them, including EH29, EH30 and KY11. Give us your postcode when you enquire and we will confirm the visit details.
What is the difference between VRF and VRV?
None in practice. VRV is one manufacturer's trademark; VRF is the generic name for the same type of system.
Can VRF connect to our BMS?
Yes, through the manufacturer's interface. We specify the right gateway at design stage.
Get a guide price for Queensferry
Free survey and fixed written quote. We reply with a guide price or to book the survey.